GTI9000Bootloader¶

Boot log¶

reading nps status file is successfully!.
nps status=0x504d4f43
PMIC_IRQ1    = 0xc0 
PMIC_IRQ2    = 0x0 
PMIC_IRQ3    = 0x0 
PMIC_IRQ4    = 0x0 
PMIC_STATUS1 = 0x80 
PMIC_STATUS2 = 0x0 
get_debug_level current debug level is 0x574f4c44.
aries_process_platform: Debug Level Low
keypad_scan: key value ----------------->= 0x40
CONFIG_ARIES_REV:48 , CONFIG_ARIES_REV03:48 
aries_process_platform: final s1 booting mode = 0
DISPLAY_PATH_SEL[MDNIE 0x1]is on
MDNIE setting Init start!!
vsync interrupt is off
video interrupt is off
[fb0] turn on
MDNIE setting Init end!!

Autoboot (0 seconds) in progress, press any key to stop 
get_debug_level current debug level is 0x574f4c44.
get_debug_level current debug level is 0x574f4c44.
boot_kernel: Debug Level Low
FOTA Check Bit 
 Read BML page=, NumPgs=
FOTA Check Bit (0xffffffff)
Load Partion idx = (6)
..............................done
Kernel read success from kernel partition no.6, idx.6.
setting param.serialnr=0xxxxxxxxx 0xxxxxxxxx
setting param.board_rev=0x30
setting param.cmdline=console=ttySAC2,115200 loglevel=4

Starting kernel at 0x32000000...

Available commands¶

SBL> help  
Following commands are supported:
* setenv
* saveenv
* printenv
* help
* reset
* boot
* kernel
* format
* open
* close
* erasepart
* eraseall
* loadkernel
* showpart
* addpart
* delpart
* savepart
* nkernel
* nramdisk
* nandread
* nandwrite
* usb
* mmctest
* keyread
* usb_read
* usb_write
* fuelgauge
* pmic_read
* pmic_write
To get commands help, Type "help <command>" 

Environment¶

SBL> printenv
PARAM Rev 1.3
SERIAL_SPEED : 7
LOAD_RAMDISK : 0
BOOT_DELAY : 0
LCD_LEVEL : 97
SWITCH_SEL : 1
PHONE_DEBUG_ON : 0
LCD_DIM_LEVEL : 0
LCD_DIM_TIME : 6
MELODY_MODE : 1
REBOOT_MODE : 3
NATION_SEL : 0
LANGUAGE_SEL : 0
SET_DEFAULT_PARAM : 0
PARAM_INT_13 : 0
PARAM_INT_14 : 0
VERSION : I9000XXIL
CMDLINE : console=ttySAC2,115200 loglevel=4
DELTA_LOCATION : /mnt/rsv
PARAM_STR_3 : 
PARAM_STR_4 :