UART » History » Version 17
Denis 'GNUtoo' Carikli, 11/27/2018 05:16 PM
| 1 | 1 | Denis 'GNUtoo' Carikli | h1. Serial port |
|---|---|---|---|
| 2 | |||
| 3 | 12 | Denis 'GNUtoo' Carikli | There is an in-depth article covering several Samsung devices in the [[SamsungSerial]] page |
| 4 | 11 | Denis 'GNUtoo' Carikli | |
| 5 | 1 | Denis 'GNUtoo' Carikli | h2. Settings |
| 6 | 12 | Denis 'GNUtoo' Carikli | |
| 7 | 14 | Denis 'GNUtoo' Carikli | |_. Device |_. I/O voltage |_. ID<->GND |_. SOC TX |_. SOC RX |_. switch |_. Comments | |
| 8 | | I9300 | 1.8V (measured between USB GND and USB VCC) | "619kOhms":https://git.replicant.us/replicant/kernel_samsung_smdk4412/tree/drivers/misc/max77693-muic.c#n102 | D- | D+ | | It gives a shell once Replicant has booted | |
||
| 9 | 15 | Denis 'GNUtoo' Carikli | | [[NexusSI902xSerial|Nexus S]] | | [[NexusSI902xSerial#Hardware-setup|150 kOhm]] | | | FSA9480 | | |
| 10 | 13 | Denis 'GNUtoo' Carikli | | [[GalaxyNexusI9250SerialConsole|Galaxy Nexus]] | | | | | | | |
| 11 | 17 | Denis 'GNUtoo' Carikli | | [[OptimusBlackSerial|Optimus Black]] | | N/A[1] | | | | | |
| 12 | |||
| 13 | fn1. Code is required to use the switch as you need to configure both the MUIC and DP3T switch |